Kia Soul: Smart Key Unit Installation
Kia Soul 2014-2019 PS Service Manual / Body Electrical System / Smart Key System / Smart Key Unit Installation
Smart Key Unit
| 1. |
Install the smart key unit.
|
| 2. |
Connect the connector and install the smart key unit.
|
| 3. |
Install the main crash pad assembly.
|
| 4. |
Install the negative (-) battery terminal and check the smart
key system.
|
Interior Antenna 1
| 1. |
Install the interior antenna.
|
| 2. |
Install the floor console assembly.
|
| 3. |
Install the negative (-) battery terminal and check the smart
key system.
|
Interior Antenna 2
| 1. |
Install the interior antenna 2.
|
| 2. |
Install the rear seat cushion assembly.
|
| 3. |
Install the negative (-) battery terminal and check the smart
key system.
|
Exterior Bumper Antenna
| 1. |
Install the exterior bumper antenna.
|
| 2. |
Install the rear bumper cover.
|
| 3. |
Install the negative (-) battery terminal and check the smart
key system.
|
Buzzer
| 1. |
Install the buzzer.
|
| 2. |
Install the front left wheel guard.
|
| 3. |
Install the negative (-) battery terminal and check the smart
key system.
|
Door Outside Handle
| 1. |
Install the door outside handle.
|
| 2. |
Install the door trim.
|
| 3. |
Install the negative (-) battery terminal and check the smart
key system.
|
Tailgate Open Switch
| 1. |
Install the tailgate open switch.
|
| 2. |
Install the tailgate trim.
|
| 3. |
Install the negative (-) battery terminal and check the smart
key system.
|
Smart Key Unit Removal
Smart Key Unit
1.
Disconnect the negative (-) battery terminal.
2.
Remove the main crash pad assembly.
(Refer to ...
Smart Key Diagnostic Inspection
Self Diagnosis With GDS
Smart key system defects can be quickly diagnosed with the GDS. GDS
operates actuator quickly to monitor, input/output value and self diagnosis.
The followi ...
See also:
Aux, USB and iPod®* port (if equipped)
If your vehicle has an aux and/or USB(universal serial bus) port or iPod® port,
you can use an aux port to connect audio devices and an USB port to plug in an USB
and also an iPod® port to p ...
Rear Disc Brake. Replacement
Rear brake pads
1.
Remove the front wheel & tire.
2.
Loosen the guide rod bolt (B) and the remove the rear caliper
body (A).
...
Alternator Circuit Diagram
•
COM signal - When
controlling the voltage generated, the ECM sends the target
...