Kia Soul: Removal - Vehicle Speed Sensor - Manual Transaxle SystemKia Soul: Removal

Kia Soul 2014-2019 PS Service Manual / Manual Transaxle System / Vehicle Speed Sensor / Removal

1.
Remove the air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
2.
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
3.
Disconnect the vehicle speed sensor connector (A).
4.
Remove the vehicle speed sensor (A) and driven gear.
Tightening torque:
4.9 ~ 6.9 N.m (0.5 ~ 0.7 kgf.m, 3.6 ~ 5.1 lb.ft)

  
After removing speed sensor, be careful not to enter dust, foreign matters, etc in speed sensor hole.
5.
Separate the vehicle speed sensor (A) and driven gear (B).
    Inspection
    W/Harness Inspection 1. Check the vehicle speed sensor by using the scan tool. (if normal, current vehicle speed is display) 2. Chec ...

    Installation
    1. Install in the reverse order of removal.    Do not reuse the O-ring (A). ...

    See also:

    Certification label
    The certification label is located on the driver's door sill at the center pillar. This label shows the maximum allowable weight of the fully loaded vehicle. This is called the GVWR (Gross ...

    Warnings and indicators
    All warning lights are checked by turning the ignition switch ON (do not start the engine). Any light that does not illuminate should be checked by an authorized Kia dealer. After starting the en ...

    Stowing the rear seat belt
    The rear seat belt buckles can be stowed in the pocket between the rear seatback and cushion when not in use. Routing the seat belt webbing through the rear seat belt guides will help keep th ...