Kia Soul: Oil Pressure Switch Removal and Installation - Lubrication System - Engine Mechanical SystemKia Soul: Oil Pressure Switch Removal and Installation

Kia Soul 2014-2019 PS Service Manual / Engine Mechanical System / Lubrication System / Oil Pressure Switch Removal and Installation

1.
Remove the under cover.
2.
Remove the oil drain plug, and drain the oil into a container.
3.
Remove the oil pressure switch(A).

Tightening torque :
7.8 ~ 11.7 N.m (0.8 ~ 1.2 kgf.m, 5.7 ~ 8.6 lb-ft)

4.
Install in the reverse order of removal
  
When installing the oil pressure switch, apply seal lock to the thread.

Seal lock : THREEBOND 2403
Thickness : 0.2 ~ 0.4 mm (0.008 ~ 0.016 in)

    Oil Pump Removal and Installation
    1. Remove the timing chain cover. (Refer to Timing System - "Timing Chain Cover") 2. Remove the pump cover (A). ...

    Oil Pressure Switch
    1. Check the continuity between the terminal and the body with an ohmmeter. If there is no continuity, replace the oil pressure switch. ...

    See also:

    Component Location
    1. Slide motor 2. Front height motor 3. Rear height motor 4. Recline motor 5. Lumbar support motor 6. Power seat switch 7. Recline switch 8. Lumba ...

    Front Door Inside Handle Replacement
    1. Remove the front door trim. (Refer to Front Door - "Front Door Trim") 2. Loosen the front door inside handle mounting scre ...

    Hood Latch Replacement
    [Hood upper latch assembly] 1. After loosening the mounting bolt, then remove the hood upper latch assembly (A). Tightening torque : ...