Clutch Release Cylinder Air Bleeding
Procedure |
•
|
Use the specified fluid. Avoid mixing different brands
of fluid.
|
|
1. |
After disconnecting a cap from the clutch release cylinder air
bleeder, insert a vinyl hose in the plug.
|
2. |
Refill the clutch master cylinder with the specified fluid.
Specified fluid:
SAE J1703 (DOT 3 or DOT 4)
|
|
3. |
Loosening the plug screw, press and release the clutch pedal about
10 times.
|
4. |
Tighten the plug (A) during the clutch pedal pressed. Afterwards,
raise the pedal with a hand.
|
5. |
After pressing the clutch pedal 3 times more, loosen the plug
(A) and re-tighten it with the pedal pressed. Raise it again, then.
|
6. |
Repeat the step 4 two or three times.
(until there is no bubble in the fluid)
Tightening torque:
6.8 ~ 9.8 N.m (0.7 ~ 1.0 kgf.m, 5.0 ~ 7.2 lb-ft)
|
|
7. |
Refill the clutch master cylinder with the specified fluid.
Specified fluid:
SAE J1703 (DOT 3 or DOT 4)
|
|
1.
Install in the reverse order of removal.
Apply the specified grease to ...
See also:
Air intake control
This is used to select outside (fresh) air position or recirculated air position.
To change the air intake control position, push the control button.
Recirculated air position
The indicator lig ...
Vehicle certification label
The vehicle certification label attached on the driver’s side center pillar gives
the vehicle identification number (VIN). ...
Component Location
1. Power door mirror
2. Power door mirror switch
3. Power folding mirror switch
...