1. |
Install the hub bearing to the knuckle assembly.
(1) |
Lay the knuckle assembly (A) on press.
|
(2) |
Lay a new hub bearing upon the knuckle assembly (A).
|
(3) |
Lay a suitable adapter (B) upon the hub bearing.
|
(4) |
Install the hub bearing to the knuckle assembly by using
press.
|
- |
Do not press against the inner race of the hub
bearing because that can cause damage to the bearing
assembly.
|
- |
Always use a new wheel bearing assembly.
|
|
|
2. |
Install the hub assembly to the knuckle assembly.
(1) |
Lay the hub assembly (A) upon a suitable adapter .
|
(2) |
Lay the knuckle assembly (B) upon the hub assembly (A).
|
(3) |
Lay a suitable adapter (C) upon the hub bearing.
|
(4) |
Install the hub assembly (A) to the knuckle assembly (B)
by using press.
|
Do not press against the inner race of the hub bearing
because that can cause damage to the bearing assembly.
|
|
3. |
Install the snap ring (A).
|
1.
Remove the snap ring (A).
2.
Remove the hub assembly from the knuckle assembly.
(1)
Install the ...
1.
Check the hub for cracks and the splines for wear.
2.
Check the brake disc for scoring and damage.
3.
C ...
See also:
Tire Wear
1.
Measure the tread depth of the tires.
Tread depth [limit] :
1.6 mm (0.0630 in.)
2.
If the re ...
Bulb wattage
...
Operation
Evaporative System Monitoring
Evaporative And ORVR Emission Control System
This system consists of a fill vent valve, fuel shut-off valve, fuel cut
valve (for roll over), two way val ...