1. |
Remove the snap ring (A).
|
2. |
Remove the hub assembly from the knuckle assembly.
(1) |
Install the front knuckle assembly (A) on press.
|
(2) |
Lay a suitable adapter (B) upon the hub assembly shaft.
|
|
3. |
Remove the hub bearing inner race from the hub assembly.
(1) |
Install a suitable tool (A) for removing the hub bearing
inner race on the hub assembly.
|
(2) |
Lay the hub assembly and tool (A) upon a suitable adapter
(B).
|
(3) |
Lay a suitable adapter (C) upon the hub assembly shaft.
|
(4) |
Remove the hub bearing inner race (D) from the hub assembly
by using press.
|
|
4. |
Remove the hub bearing outer race from the knuckle assembly.
(1) |
Lay the hub assembly (A) upon a suitable adapter (B).
|
(2) |
Lay a suitable adapter (C) upon the hub bearing outer
race.
|
(3) |
Remove the hub bearing outer race from the knuckle assembly
by using press.
|
|
5. |
Replace hub bearing with a new one.
|
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the front wheel and tire (A) fro ...
1.
Install the hub bearing to the knuckle assembly.
(1)
Lay the knuckle assembly (A) on press.
(2)
...
See also:
Cool box (if equipped)
You can keep beverage cans or other items cool in the glove box.
1. Turn on the air conditioning.
2. Slide the open/close lever of the vent installed in the glove box to the open
position.
3. ...
Intake Actuator Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the intake actuator connector.
3.
Verify that the intake actuato ...
Rear Disc Brake. Removal
Brake caliper assembly
1.
Remove the front wheel & tire.
Tightening torque :
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft ...