Kia Soul: Dynamic Damper Replacement - Driveshaft Assembly - Driveshaft and axleKia Soul: Dynamic Damper Replacement

Kia Soul 2014-2019 PS Service Manual / Driveshaft and axle / Driveshaft Assembly / Dynamic Damper Replacement

1.
Remove the front driveshaft.
(Refer to Driveshaft Assembly - “Front Driveshaft”)
2.
Remove the TJ joint assembly.
(Refer to Driveshaft Assembly - “TJ joint”)
3.
Remove the remove the both side of band (B) of the dynamic damper (A).

4.
Fix the driveshaft (A) with a vice (B) as illustrated.

5.
Apply soap powder on the shaft to prevent being damaged between the shaft spline and the dynamic damper when the dynamic damper is removed.
6.
Seperate the dynamic damper (A) from the shaft (B) carefully.

    Dynamic Damper Components
    1. BJ assembly 2. BJ circlip 3. BJ boot band 4. BJ boot 5. Dynamic damper band 6. Dynamic damper 7. Shaft 8. TJ boot band 9. TJ boot 10. Spider assembly ...

    Dynamic Damper Installation
    1. Apply soap powder on the shaft to prevent being damaged between the shaft spline and the dynamic damper. 2. Install the dynamic damper. ...

    See also:

    Smart key immobilizer system
    Your vehicle is equipped with an electronic engine immobilizer system to reduce the risk of unauthorized vehicle use. Your immobilizer system is comprised of a small transponder in the smart key ...

    Steering Gear box. Replacement
    1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Loosen the bolt and then disconnec ...

    Thermostat Inspection
    1. Immerse the thermostat in water and gradually heat the water. 2. Check the valve opening temperature. Valv ...