Kia Soul: Dynamic Damper Installation - Driveshaft Assembly - Driveshaft and axleKia Soul: Dynamic Damper Installation

Kia Soul 2014-2019 PS Service Manual / Driveshaft and axle / Driveshaft Assembly / Dynamic Damper Installation

1.
Apply soap powder on the shaft to prevent being damaged between the shaft spline and the dynamic damper.
2.
Install the dynamic damper.
3.
Install the dynamic damper band (A).
4.
Using the SST(09495-3K000), secure the TJ boot bands (B).

Clearance (A): 2.0 mm (0.0787 in.) or less

5.
Install the TJ joint assembly.
(Refer to Driveshaft Assembly - “TJ Joint”)
6.
Install the front driveshaft.
(Refer to Driveshaft Assembly - “Front Driveshaft”)
7.
Check the front alignment.
(Refer to Suspension System - "Front Alignment")
    Dynamic Damper Replacement
    1. Remove the front driveshaft. (Refer to Driveshaft Assembly - “Front Driveshaft”) 2. Remove the TJ joint assembly. (Refe ...

    BJ Boot Components
    1. BJ assembly 2. BJ circlip 3. BJ boot band 4. BJ boot 5. Dynamic damper band 6. Dynamic damper 7. Shaft 8. TJ boot band 9. TJ boot 10. Spider assembly ...

    See also:

    Inspection
    Signal Circuit Inspection 1. Check clutch switch pull-up voltage (1) IG KEY "OFF", ENGINE "OFF". ...

    My Music
    Even if memory is available, a maximum of 6,000 songs can be stored. The same song can be copied up to 1,000 times. Memory info can be checked in the System menu of Setup. ...

    Components
    1. Front seat belt pretensioner 2. Height adjuster 3. Rear seat belt retractor 4. Rear seat belt buckle [LH] 5. Rear seat belt buckle [RH] ...