Kia Soul: Disc brakes and pads Replacement - Chassis - MaintenanceKia Soul: Disc brakes and pads Replacement

Kia Soul 2014-2019 PS Service Manual / Maintenance / Chassis / Disc brakes and pads Replacement

Front brake pads
1.
Remove the front wheel & tire.
2.
Loosen the guide rod bolt (B) and pivot the caliper body (A) up out of the way.

3.
Replace pad shim (D), pad retainers (C) and brake pads (B) in the caliper carrier (A).

4.
Compress the piston into the caliper body using the SST (09581-11000).

5.
Place the caliper body (A) on the caliper carrier and tighten the guide rod bolt (B).

Tightening torque :
21.6 ~ 31.4 N.m (2.2 ~ 3.2 kgf.m, 15.9 ~ 23.1 lb-ft)

6.
Install the front wheel & tire.

Tightening torque :
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)

Rear Brake Pads
1.
Remove the front wheel & tire.
2.
Loosen the guide rod bolt (B) and the remove the rear caliper body (A).

Tightening torque :
21.6 ~ 31.4 N.m (2.2 ~ 3.2 kgf.m, 15.9 ~ 23.1 lb-ft)

3.
Replace pad retainers (C) and brake pads (B) in the caliper carrier (A).

4.
Rotate the caliper piston and push the direction of the arrow.

5.
Place the caliper body (A) on the caliper carrier and tighten the guide rod bolt (B).

Tightening torque :
21.6 ~ 31.4 N.m (2.2 ~ 3.2 kgf.m, 15.9 ~ 23.1 lb-ft)

  
Assemble the caliper body so that the piston groove (A) is in-line with the pad center lobe (B).

* Make sure that the piston and pad are tightly attached.
6.
Install the front wheel & tire.

Tightening torque :
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)

    Disc brakes and pads Inspection
    Check the pads for excessive wear, discs for run out and wear, and calipers for fluid leakage. Front Brake Front Brake Disc Thickness Check 1. Check the ...

    Drive shafts and boots Inspection
    1. Check the drive shaft boots for loose clamps, cracks, grease leaks, kinks or damage. ...

    See also:

    A/C Pressure Transducer Description
    The A/C Pressure Transducer (APT) converts the pressure value of high pressure line into voltage value after measuring it. By converted voltage value, engine ECU controls the cooling fan by o ...

    Ignition Coil Circuit Diagram
    [MT] [AT] ...

    Accelerator Pedal. Repair procedures
    Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. ...