Kia Soul: Gauges - Instrument cluster - Features of your vehicleKia Soul: Gauges

Kia Soul 2014-2019 PS Owner's Manual / Features of your vehicle / Instrument cluster / Gauges

Speedometer

The speedometer indicates the speed of the vehicle and is calibrated in miles

The speedometer indicates the speed of the vehicle and is calibrated in miles per hour (mph) and/or kilometers per hour (km/h).

Tachometer

The tachometer indicates the approximate number of engine revolutions per minute

The tachometer indicates the approximate number of engine revolutions per minute (rpm).

Use the tachometer to select the correct shift points and to prevent lugging and/or over-revving the engine.

CAUTION

Do not operate the engine within the tachometer's RED ZONE. This may cause severe engine damage.

Engine Coolant Temperature Gauge

This gauge indicates the temperature of the engine coolant when the ignition

This gauge indicates the temperature of the engine coolant when the ignition switch or Engine Start/Stop button is ON.

CAUTION

If the gauge pointer moves beyond the normal range area toward the “H” position, it indicates overheating that may damage the engine. Do not continue driving with an overheated engine. If your vehicle overheats, refer to “If the Engine Overheats” in chapter 6.

WARNING

Never remove the radiator cap when the engine is hot. The engine coolant is under pressure and could severely burn. Wait until the engine is cool before adding coolant to the reservoir.

Fuel Gauge

This gauge indicates the approximate amount of fuel remaining in the fuel tank.

This gauge indicates the approximate amount of fuel remaining in the fuel tank.

✽ NOTICE

  • The fuel tank capacity is given in chapter 8.
  • The fuel gauge is supplemented by a low fuel warning light, which will illuminate when the fuel tank is nearly empty.
  • On inclines or curves, the fuel gauge pointer may fluctuate or the low fuel warning light may come on earlier than usual due to the movement of fuel in the tank.

WARNING - Fuel Gauge

Running out of fuel can expose vehicle occupants to danger. You must stop and obtain additional fuel as soon as possible after the warning light comes on or when the gauge indicator comes close to the “E (Empty)” level.

CAUTION

Avoid driving with a extremely low fuel level. Running out of fuel could cause the engine to misfire damaging the catalytic converter.

✽ NOTICE

Fuel display may not be accurate if you are filling in sloping places.

Odometer

The odometer Indicates the total distance that the vehicle has been driven and

The odometer Indicates the total distance that the vehicle has been driven and should be used to determine when periodic maintenance should be performed.

- Odometer range : 0 ~ 999999 miles or kilometers.

Outside Temperature Gauge

This gauge indicates the current outside air temperatures by 1°F (1°C).

This gauge indicates the current outside air temperatures by 1°F (1°C).

- Temperature range : -40°F ~ 140°F (-40°C ~ 60°C)

The outside temperature on the display may not change immediately like a gv thermometer to prevent the driver from being inattentive.

To change the temperature unit (from °C to °F or from °F to °C)

Type A Cluster

Press the RESET button 5 times and then press the Trip button 5 times within 10 seconds.

Type B Cluster

The temperature unit can be changed by using the "User Settings" mode of the LCD display

    LCD Display Control
    The LCD display modes can be changed by using the control buttons on the steering wheel. [For type A cluster] (1) TRIP : TRIP button for changing trip modes (2) RESET : RESET button for r ...

    Transaxle Shift Indicator
    Automatic Transaxle Shift Indicator This indicator displays which automatic transaxle shift lever is selected. Park :P Reverse : R Neutral : N Drive :D Sports Mode : 1, 2, 3, 4, 5, 6 ...

    See also:

    Alternator Specification
    Alternator ltem Specification Nominal output 13.5V, 110A Speed in use 1,000 ~ 18,000 rpm Voltage regulator IC Regulator bu ...

    Front Wheel Guard Replacement
       • Put on gloves to protect your hands. ...

    Photo Sensor Inspection
    1. Turn the ignition switch ON. 2. Connect the GDS. 3. Emit intensive light toward the photo sensor using a lam ...