Kia Soul: Torque Converter Control Solenoid Valve (T/CON_VFS). Removal - Automatic Transaxle Control System - Automatic Transaxle SystemKia Soul: Torque Converter Control Solenoid Valve (T/CON_VFS). Removal

Kia Soul 2014-2019 PS Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Torque Converter Control Solenoid Valve (T/CON_VFS). Removal

1.
Remove the under cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover")
2.
Remove the drain plug (A) and drain the ATF totally and then reinstall the drain plug.

Tightening torque :
33.3 ~ 43.1 N.m (3.4 ~ 4.4 kgf.m, 24.6 ~ 31.8 lb-ft)

  
Must be replaced with new gasket when installing the drain plug.
3.
Remove the air cleaner assembly and air duct.
(Refer to Engine Mechanical System - "Air cleaner")
4.
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
5.
Remove the wiring bracket (A).

Tightening torque :
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

6.
Remove the air breather hose (A).
7.
Remove the valve body cover (B).

Tightening torque:
11.8 ~ 13.7 N.m (1.2 ~ 1.4 kgf.m, 8.7 ~ 10.1 lb-ft)

8.
Remove the solenoid valve connector (B) and the oil temperature sensor (A).

9.
Remove the solenoid valve support bracket (B) and the valve body mounting bolt (A-1ea).

Tightening torque :
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

10.
Remove the torque converter control solenoid valve (A).

    Torque Converter Control Solenoid Valve (T/CON_VFS). Inspection
    1. Turn ignition switch OFF. 2. Disconnect the solenoid valve connector (A). 3. Measure resistance bet ...

    Torque Converter Control Solenoid Valve (T/CON_VFS). Installation
    1. Install in the reverse order of removal.    • Adding Automa ...

    See also:

    Answering Calls
    Answering a Call Answering a call with a Bluetooth® Wireless Technology device connected will display the following screen. To accept the call, press key on the steering wheel while the call ...

    Refrigerant label
    The refrigerant label is located on the underside of the hood. ...

    Installation
    1. Install in the reverse order of removal. (1) Tighten the nut with the specified torque. Tightening ...