Kia Soul: Thermostat Installation - Cooling System - Engine Mechanical SystemKia Soul: Thermostat Installation

Kia Soul 2014-2019 PS Service Manual / Engine Mechanical System / Cooling System / Thermostat Installation

1.
Place the thermostat in the block.
Install the thermostat (B) with the jiggle valve upward.
2.
Install the water inlet fitting (A).

Tightening torque :
18.6 ~ 23.5N.m (1.9 ~ 2.4kgf.m, 13.7 ~ 17.4lb-ft)

3.
Fill with engine coolant.
4.
Start engine and check for leaks.
    Thermostat Inspection
    1. Immerse the thermostat in water and gradually heat the water. 2. Check the valve opening temperature. Valv ...

    Thermostat Troubleshooting
    Symptoms Possible Causes Remedy Coolant leakage • From the thermostat gasket Check the mounting ...

    See also:

    Smooth cornering
    Avoid braking or gear changing in corners, especially when roads are wet. Ideally, corners should always be taken under gentle acceleration. If you follow these suggestions, tire wear will be ...

    Rear Wiper Motor Inspection
    Rear Wiper Motor 1. Remove the connector from the rear wiper motor. 2. Connect battery positive (+) and negative (-) cable ...

    Engine oil flow diagram
    ...