Kia Soul: Steering Column Shroud Panel Replacement - Crash Pad - Body (Interior and Exterior)Kia Soul: Steering Column Shroud Panel Replacement

Kia Soul 2014-2019 PS Service Manual / Body (Interior and Exterior) / Crash Pad / Steering Column Shroud Panel Replacement

[Steering column shroud lower panel]
  
•
Put on gloves to protect your hands.
  
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the crash pad lower panel.
(Refer to Crash Pad - "Crash Pad Lower Panel")
2.
After loosening the mounting screws, then remove the steering column shroud lower panel (A) by using a screw driver.
3.
Install in the reverse order of removal.
  
•
Replace any damaged clips.
[Steering column shroud upper panel]
  
•
Put on gloves to protect your hands.
  
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the cluster fascia panel.
(Refer to Crash Pad - "Cluster Fascia Panel")
2.
Install in the reverse order of removal.
  
•
Replace any damaged clips.
    Steering Column Shroud Panel Component Location
    1. Steering column shroud lower panel 2. Steering column shroud upper panel ...

    Crash Pad Side Cover Component Location
    [LH] 1. Crash pad side cover [LH] [RH] 1. Crash pad side cover [RH] ...

    See also:

    Headlamp escort (if equipped)
    If you turn the ignition switch to the ACC or OFF position with the headlights ON, the headlights remain on for about 5 minutes. However, if the driver’s door is opened and closed, the headlight ...

    Rear Door Side Weatherstrip Replacement
    1. Loosen the rear door checker (B) mounting bolt. Tightening torque : 16.7 ~ 21.6 N.m (1.7 ~ 2.2 kgf.m, 12.3 ~ 15.9 lb-ft) ...

    Overhead Console Lamp Inspection
    1. Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch. ...