Kia Soul: SS-B Solenoid Valve(ON/OFF). Removal

1.	Remove the under cover. (Refer to Engine Mechanical System - "Engine Room Under Cover")

Remove the drain plug (A) and drain the ATF totally and then reinstall the drain plug.

Tightening torque :

33.3 ~ 43.1 N.m (3.4 ~ 4.4 kgf.m, 24.6 ~ 31.8 lb-ft)

Must be replaced with new gasket when installing the drain plug.

3.	Remove the air cleaner assembly and air duct. (Refer to Engine Mechanical System - "Air cleaner")

4.	Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery")

Remove the wiring bracket (A).

Tightening torque :

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

6.	Remove the air breather hose (A).

Remove the valve body cover (B).

Tightening torque:

11.8 ~ 13.7 N.m (1.2 ~ 1.4 kgf.m, 8.7 ~ 10.1 lb-ft)

8.	Remove the solenoid valve connector (B) and the oil temperature sensor (A).

9.	Remove the solenoid valve (B) after removing the solenoid support (A).

1. Turn ignition switch OFF. 2. Disconnect the solenoid valve connector (A). 3. Measure resistance bet ...

1. Installation is the reverse of removal. • ...