Kia Soul: SRS Control Module (SRSCM). Removal
| 1. |
Remove the ignition key from the vehicle.
|
| 2. |
Disconnect the battery negative cable and wait for at least three
minutes before beginning work.
|
| 3. |
Disconnect the DAB, PAB, SAB, CAB and BPT connectors.
|
| 4. |
Remove the floor console.
(Refer to Body - "Floor console")
|
| 5. |
Remove the rear heating joint duct (A).
|
| 6. |
Pull up the lock of the SRSCM connector and disconnect the connector
(A).
|
| 7. |
Remove the SRSCM mounting bolts(3EA) from the SRSCM, then remove
the SRSCM.
|
SRS Control Module (SRSCM). Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three
minutes before beginning ...
See also:
Distributing the sealant
11. Immediately drive approximately 4~6miles (7~10km or, about 10min) to evenly
distribute the sealant in the tire.
Do not exceed a speed of 50 mph (80 km/h). If possible, do not fall below a speed ...
SRS Control Module (SRSCM). Description
The primary purpose of the SRSCM (Supplemental Restraints System Control
Module) is to discriminate between an event that warrants restraint system deployment
and an event that does not. The ...
Room Lamp Inspection
1.
Check that the switch operates properly after disconnecting
the room lamp connector (A).
Room Lamp
Personal Lamp
...