| Pressure Side Impact Sensor |
|
1. |
Install the new pressure side impact sensor with the screws (B)
and then connect the pressure side impact sensor connector (A).
Tightening torque :
3.5 ~ 5.7 N.m (0.4 ~ 0.6 kgf.m, 2.6 ~ 4.2 lb-ft)
|
|
• |
Use the specified screws.
|
|
|
|
2. |
Install the front door trim.
(Refer to Body - "Front door trim")
|
|
3. |
Reconnect the battery negative cable.
|
|
4. |
After installing the pressure side impact sensor, confirm proper
system operation:
| A. |
Turn the ignition switch ON; the SRS indicator light should
be turned on for about six seconds and then go off.
|
|
• |
You must comply with the specified tightening
torques with the tool specified because Pressure – Side
Impact Sensors (P-SIS) may be broken or screw gromment
may be rotated.
|
|
• |
Problems may be occurred in the durability of
P-SIS or impact sensing performance may be depreciated
if screw gromment is rotated.
|
|
• |
The door module must not be transformed because
SRSCM judges a impact through the pressure sensor in
the door module.
|
|
|
Side Impact Sensor
| •
|
Do not turn the ignition switch ON and do not connect
the battery cable while replacing the side impact sensor.
|
|
|
1. |
Install the new side impact sensor (B) with the bolt then connect
the side impact sensor connector (A).
Tightening torque:
7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.7 ~ 7.3 lb-ft)
|
|
|
2. |
Install the center pillar lower trim.
(Refer to Body - "Center pillar trim")
|
|
3. |
Insert the seat belt to the emergency fastening device (A).
|
Make sure the lock pin is connected in properly.
|
|
|
4. |
Reconnect the battery negative cable.
|
|
5. |
After installing the Side Impact Sensor, confirm proper system
operation:
| A. |
Turn the ignition switch ON; the SRS indicator light should
be turned on for about six seconds and then go off.
|
|
Pressure Side Impact Sensor
•
Removal of the airbag must be performed according ...
The SRSCM shall monitor the status of the driver and front passenger seat
belt buckle. The SRSCM provides one pin each for the driver and front passenger
seat belt buckle status input. The se ...
Kia Soul: Side Impact Sensor (SIS). Installation
Side Impact Sensor (SIS). Removal
Seat Belt Buckle Switch (BS). Description