Kia Soul: Shift Lever Removal - Manual Transaxle Control System - Manual Transaxle SystemKia Soul: Shift Lever Removal

Kia Soul 2014-2019 PS Service Manual / Manual Transaxle System / Manual Transaxle Control System / Shift Lever Removal

1.
Rotating counter-clockwise shift lever knob (A).

2.
Remove the floor console assembly.
(Refer to Body - "Floor Console")
3.
Remove the rear heating joint duct (A).

4.
Remove the bracket (A).

5.
Remove the select cable (B) after removing the snap pin (A).
6.
Remove the cable socket (C) from lever assembly after pulling in the direction of the arrow.

7.
Remove the shift cable (B) after removing the clip (A).

8.
Remove the cable socket (A) from lever assembly after pulling in the direction of the arrow.

9.
Remove the shift lever assembly (B) by removing the bolts (A).

Tightening torque:
8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)

    Shift Lever Components
    1. Knob 2. Boots 3. Shift lever assembly 4. Select cable clip 5. Shift cable 6. Select cable 7. Cable retainer ...

    Shift Lever Installation
    1. Install in the reverse order of removal.    When installing, set room sid ...

    See also:

    Blower Resistor (Manual) Inspection
    1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replac ...

    Rail Pressure Sensor (RPS). Schematic Diagrams
    Circuit Diagram (M/T) (A/T) ...

    Cruise Control Switch Removal
    1. Disconnect the negative (-) battery terminal. 2. Remove the driver airbag module. (Refer to the RT group) 3. ...