Kia Soul: Removal - Clutch Release Cylinder - Clutch SystemKia Soul: Removal

Kia Soul 2014-2019 PS Service Manual / Clutch System / Clutch Release Cylinder / Removal

1.
Drain the brake fluid through the bleed plug (A).
  
•
Do not spill brake fluid on the vehicle; it may damage the paint if brake fluid does contact the paint, wash it off immediately with water.

2.
Remove the clutch release cylinder assembly (C) after removing the tube (B) and bolts (A-2ea).
Tightening torque:
14.7 ~ 21.6 N.m (1.5 ~ 2.2 kgf.m,10.8 ~ 15.9 lb-ft)

    Inspection
    1. Check the clutch release cylinder for fluid leakage. 2. Check the clutch release cylinder boot for damage. ...

    Installation
    1. Install in the reverse order of removal.    Apply the specified grease to ...

    See also:

    SS-A Solenoid Valve(ON/OFF). Removal
    1. Remove the under cover. (Refer to Engine Mechanical System - "Engine Room Under Cover") 2. Remove the drain plug (A) and dr ...

    Customer Complaint Analysis Check Sheet
    Troubleshooting (Flow chart type) There are six areas where a problem can occur: wiring harness, the radio, the USB/iPod, and speaker. Troubleshooting enables you to confine ...

    Temperature Control Actuator Inspection
    1. Turn the ignition switch OFF. 2. Disconnect the temperature control actuator connector. 3. Verify that the t ...