Kia Soul: Rear Oil Seal Installation - Cylinder Block - Engine Mechanical SystemKia Soul: Rear Oil Seal Installation

Kia Soul 2014-2019 PS Service Manual / Engine Mechanical System / Cylinder Block / Rear Oil Seal Installation

1.
Install the rear oil seal.
(1)
Apply engine oil to a new oil seal lip.
(2)
Using the SST(09231-H1100, 09231-2B200) and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.
2.
MT : Install the flywheel.
(Refet to Cylinder Block - "Flywheel")
3.
AT : Install the drive plate.
(Refet to Cylinder Block - "Drive Plate")
4.
Install the transaxle assembly.
(Refer to Manual Transaxle System - "Manual Transaxle")
(Refer to Automatic Transaxle System - "Automatic Transaxle")
    Rear Oil Seal Removal
    1. Remove the transaxle assembly. (Refer to Manual Transaxle System - "Manual Transaxle") (Refer to Automatic Transaxle System - "Automatic Transa ...

    Piston and Connecting Rod Components
    1. Piston ring 2. Piston 3. Piston pin 4. Connecting rod 5. Connecting rod upper bearing 6. Connecting rod lower bearing 7. Connecting rod bearing cap ...

    See also:

    SRS Control Module (SRSCM). Description
    The primary purpose of the SRSCM (Supplemental Restraints System Control Module) is to discriminate between an event that warrants restraint system deployment and an event that does not. The ...

    Tail Gate Assembly Replacement
       • Wear gloves to protect hands from injury. ...

    Drive shafts and boots
    Check the drive shafts, boots and clamps for cracks, deterioration, or damage. Replace any damaged parts and, if necessary, repack the grease. ...