Kia Soul: Power Window Switch Inspection - Power Windows - Body Electrical SystemKia Soul: Power Window Switch Inspection

Kia Soul 2014-2019 PS Service Manual / Body Electrical System / Power Windows / Power Window Switch Inspection

Power Window Main Switch Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front door trim.
(Refer to Body - "Front Door Trim")
3.
Disconnect the connector (A) from the power window switch module.

4.
Check for continuity between the terminals in each switch position according to the table.
[Driver/Assist Safety]

[Driver Auto Down]

Assist Power Window Switch Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front door trim panel.
(Refer to Body - "Front Door Trim")
3.
Disconnect the connector (A) from the switch.

4.
Check for continuity between the terminals in each switch position according to the table. If the continuity condition is not normal, replace the switch.
[Safety]

[Manual]

Rear Power Window Switch Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear door trim panel.
(Refer to Body - "Rear Door Trim")
3.
Disconnect the connector (A) from the switch.

4.
Check for continuity between the terminals in each switch position according to the table. If the continuity condition is not normal, replace the switch.
[With Seat Heater]

[Without Seat Heater]

    Power Window Switch Circuit Diagram
    Driver Power Window Switch Assist Power Window Switch Rear Power Window Switch ...

    Power Window Switch Removal
    Driver Power Window Switch 1. Disconnect the negative (-) battery terminal. 2. Remove the front door trim. (Refe ...

    See also:

    Roller Blind Removal
    1. Open the roller blind using the panorama sunroof switch.    ...

    Component
    1. Airbag module 2. Remote control upper switch 3. Remote control lower switch 4. Steering wheel assembly 5. Heated unit 6. Wiring 7. Steering wheel lower co ...

    Shift Lever. Installation
    1. Install in the reverse order of removal.    When installing, set room sid ...