Kia Soul: Panorama Sunroof Motor Replacement - Panorama Sunroof - Body Electrical SystemKia Soul: Panorama Sunroof Motor Replacement

Kia Soul 2014-2019 PS Service Manual / Body Electrical System / Panorama Sunroof / Panorama Sunroof Motor Replacement

Resetting The Panoramaroof
Whenever the vehicle battery is disconnected or discharged, or you use the emergency handle to operate the panoramaroof, you have to reset your panoramaroof system as follows :
1.
Turn the ignition key to the ON position and then close the panoramaroof completely.
2.
Release the panoramaroof control lever.
3.
Press and hold the CLOSE button for more than 10 seconds until the sunroof has moved slightly.
4.
Release the panoramaroof control lever.
5.
Press and hold the CLOSE button once again within 5 seconds until the panorama sunroof do as follows ;
A.
Blind open and glass open → Glass close → Blind close
Then release the lever.
6.
Reset procedure of panorama system is finished.
Protecting The Overheated Motor
In order to protect the overheated panoramaroof motor by continuous motor operation, the panoramaroof ECU controls the Run-time and Cool-time of motor as followings;
1.
The panoramaroof ECU detects the Run- time of motor
2.
Motor can be operated continuously for the 1st Run-time(120 ± 10sec.).
3.
Motor which is operated continuously stops operating after the 1st Run-time(120 ± 10sec.).
4.
And then Motor is not operated for the 1st Cool-time(18 ± 2sec.).
5.
Motor is operated for the 2nd Run-time(10 ± 2sec.) at the continued motor operation after 1st Cool-time(18 ± 2sec.)
6.
Motor which is operated continuously stops operating after the 2nd Run-time(10 ± 2sec.)
7.
Motor is not operated for the 2nd Cool-time(18 ± 2sec.).
8.
Motor repeats the 2nd Run-time and 2nd Cool-time at the continued motor operation.
A.
In case that motor is not operated continuously, the Run-time which is limited for protecting the overheated motor is increased.
B.
The Run-Time of motor is initialized to "0" if the battery or fuse is reconnected after being disconnected, discharged or blown.

T1 : 120 ± 10 sec., T2 : 18 ± 2 sec.,
T3 : 10 ± 2 sec., T4 : 18 ± 2 sec.
    Panorama Sunroof Motor Inspection
    1. Close the panorama sunroof glass and blind completely (Full close position). 2. Disconnect the negative (-) battery ter ...

    Roller Blind Motor Replacement
    1. Refer to the inspection procedure in the panorama sunroof motor. (Refer to the "Panorama Sunroof Motor") ...

    See also:

    Inspection
    Lighting Switch Inspection 1. With the multi function switch in each position, make sure that continuity exists between the terminals below. If conti ...

    Drive Plate Removal and Installation
    1. Remove the automatic transaxle . (Refer to Automatic Transaxle System - "Automatic Transaxle") 2. Remove the drive plate(A ...

    Manual climate control system
    1. Fan speed control knob 2. Mode selection button 3. Temperature control knob 4. Air intake control button (fresh/recirculated) 5. Front window defroster button 6. Rear window defroster button ...