Kia Soul: Intake Actuator Replacement
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the glove box housing.
(Refer to Body - "Glove Box Housing")
|
3. |
Disconnect the connector (A) and then remove the intake actuator
(B) after loosening the mounting screws.
|
4. |
Install in the reverse order of removal.
|
Intake Actuator Inspection
1. Turn the ignition switch OFF. 2. Disconnect the intake actuator connector. 3. Verify that the intake actuato ...Controller
...See also:
Underdrive Brake Control Solenoid Valve(UD/B_VFS). Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector (A).
3.
Measure resistance bet ...
Front Seat Assembly Replacement
1.
Loosen the front seat assembly mounting bolts (A).
Tightening torque :
34.3 ~ 53.9N.m (3.5 ~ 5.5kgf.m, 25.3 ~ 39.8lb-ft)
...
Driving in flooded areas
Avoid driving through flooded areas unless you are sure the water is no higher
than the bottom of the wheel hub. Drive through any water slowly. Allow adequate
stopping distance because brake perf ...