Kia Soul: Heated steering wheel (if equipped) - Steering wheel - Features of your vehicleKia Soul: Heated steering wheel (if equipped)

Kia Soul 2014-2019 PS Owner's Manual / Features of your vehicle / Steering wheel / Heated steering wheel (if equipped)

With the ignition switch in the ON position, pressing the heated steering wheel

With the ignition switch in the ON position, pressing the heated steering wheel button warms the steering wheel. The indicator on the button will illuminate.

To turn the heated steering wheel off, press the button once again. The indicator on the button will turn off.

✽ NOTICE

The heated steering wheel will turn off automatically approximately 30 minutes after the heated steering wheel is turned on.

CAUTION

  • Do not install any grip to operate the steering wheel. This causes damage to the heated steering wheel system.
  • When cleaning the heated steering wheel, do not use an organic solvent such as paint thinner, benzene, alcohol and gasoline. Doing so may damage the surface of the steering wheel.
  • If the surface of steering wheel is damaged by sharp object, damage to the heated steering wheel components could occur.
    Tilt and telescopic steering
    Tilt and telescopic steering allows you to adjust the steering wheel before you drive.You can also raise it to give your legs more room when you exit and enter the vehicle. The steering wheel sho ...

    Horn
    To sound the horn, press the horn symbols on your steering wheel. Check the horn regularly to be sure it operates properly. ✽ NOTICE To sound the horn, press the area indicated by the h ...

    See also:

    Seats
    Front seat (1) Forward and backward (2) Seatback angle (3) Seat cushion height (Driver’s seat)* (4) Seat warmer* (5) Headrest (6) Armrest (Driver’s seat)* Rear seats (7) Folding the seat ...

    Heater & A/C Control Unit (Manual) Replacement
    1. Disconnect the negative (-) battery terminal. 2. Using a screwdriver or remover, remove the center fascia panel (A). ...

    Camshaft Position Sensor (CMPS). Repair procedures
    Inspection 1. Check the signal waveform of the CMPS and CKPS using the GDS. Specification: Refer to “Wave Form” ...