Kia Soul: ETC (Electronic Throttle Control) System. Description and Operation
Kia Soul 2014-2019 PS Service Manual / Engine Control / Fuel System / Engine Control System / ETC (Electronic Throttle Control) System. Description and Operation
Description
The Electronic Throttle Control (ETC) System consists of a throttle body
with an integrated control motor and throttle position sensor (TPS). Instead
of the traditional throttle cable, an Accelerator Position Sensor (APS) is used
to receive driver input. The ECM uses the APS signal to calculate the target
throttle angle; the position of the throttle is then adjusted via ECM control
of the ETC motor. The TPS signal is used to provide feedback regarding throttle
position to the ECM. Using ETC, precise control over throttle position is possible;
the need for external cruise control modules/cables is eliminated.
f
| 1. Dry bearing 2. DC motor 3. Non-contact hall sensor 4. Gear |
5. Magnet 6. Hall IC 7. Yoke 8. Stator |
Schematic Diagram
Engine Control Module (ECM). Repair procedures
Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
2.
Remove the battery. (Refer to Engine Electrical Syst ...
ETC (Electronic Throttle Control) System. Troubleshooting
Fail-Safe Mode
Item
Fail-Safe
ETC Motor
Throttle valve stuck at 7В°
TPS
TPS 1 fault
ECM looks at TPS2
TPS 2 fault
ECM ...
See also:
Spark Plug On-vehicle Inspection
1.
Perform spark test
(1)
Remove the engine cover.
(2)
Remove the ignition coils.
...
Side repeater light bulb Type B replacement
If the light bulb is not operating, have the vehicle checked by an authorized
Kia dealer. ...
SS-A Solenoid Valve(ON/OFF). Removal
1.
Remove the under cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover")
2.
Remove the drain plug (A) and dr ...