Kia Soul: Curtain Airbag (CAB) Module. Installation - Airbag Module - RestraintKia Soul: Curtain Airbag (CAB) Module. Installation

Kia Soul 2014-2019 PS Service Manual / Restraint / Airbag Module / Curtain Airbag (CAB) Module. Installation

1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least thirty seconds.
3.
Tighten the curtain airbag mounting bolts and nuts.

Tightening torque
Bolt : 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
Nut : 3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

  
•
Never twist the airbag module when installing it. If the module is twisted, airbag module may operate abnormally.
4.
Connect the curtain airbag connector.
5.
Install the roof trim assembly.
(Refer to Body - "Roof trim assembly")
6.
Reconnect the battery negative cable.
7.
After installing the curtain airbag (CAB), confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
    Curtain Airbag (CAB) Module. Removal
    1. Disconnect the battery negative cable and wait for at least thirty seconds before beginning work. 2. Remove the roof trim assembly. ...

    Airbag Module Disposal
    Special tool required Deployment tool 0957A-34100A Before scrapping any airbags or side airbags (including those in a whole vehicle to be scrapped), the airbags or side airbags ...

    See also:

    Water Jacket Seperator Remove and Installation
    1. Remove the cylinder head assembly. (Refet to Cylinder Head Assembly - "Cylinder Head") 2. Remove the water jacket seperator ...

    35R Clutch Control Solenoid Valve(35R/C_VFS). Removal
       Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the ...

    Driving at night
    Because night driving presents more hazards than driving in the daylight, here are some important tips to remember: Slow down and keep more distance between you and other vehicles, as it may ...