Kia Soul: Control Cable Installation - Manual Transaxle Control System - Manual Transaxle SystemKia Soul: Control Cable Installation

Kia Soul 2014-2019 PS Service Manual / Manual Transaxle System / Manual Transaxle Control System / Control Cable Installation

  
When installing, set room side shift lever and T/M side lever to "4rd" gear position.
1.
Tighten the nut (B) after install the retainer (A).
Tightening torque:
11.8 ~ 14.7 N.m (1.2 ~ 1.5 kgf.m, 8.7 ~ 10.8 lb-ft)

2.
Check the Shift lever is in "4rd" gear position.
3.
Install the cable socket (A) on the shift lever assembly.
4.
Install the shift cable (B) after installing the clip (A).
5.
Install the select cable socket (C) on the shift lever assembly.
6.
Install the clip (A) after installing the select cable (B).
7.
Install the bracket (A).
8.
Install the rear heating joint duct (A).
9.
Install the floor console assembly.
(Refer to Body - "Floor Console")
10.
Rotating clockwise shift lever knob (A).
11.
Install the control cable (B) and clip (A) on the bracket.
  
Do not reuse the clip (A).

12.
Install the control cable
(1)
Install the control cable (A) in transaxle lever pin.
(2)
Ensure to press adjust locking button in direction of "C".
(3)
Install the washer (A) and pin (B).
13.
Install the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
14.
Install the air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
    Control Cable Removal
    1. Shift lever to "4rd" gear position. 2. Rotating counter-clockwise shift lever knob (A). 3. ...

    Control Cable Adjustment
    1. Remove the air cleaner assembly. (Refer to Engine Mechanical System - "Air Cleaner") 2. Remove the battery and battery tray ...

    See also:

    Temperature Control Actuator
    The heater unit includes mode control actuator and temperature control actuator. The temperature control actuator is located at the heater unit. It regulates the temperature by the proced ...

    Portable lamp usage (if equipped)
    1. In-vehicle lamp, if necessary, after separation can be used as a portable. 2. Press push button (1). 3. Pull out the lamp holder. 4. Press the power switch (2). CAUTION 1. Remove the batte ...

    Record your key number
    The key code number is stamped on the key code tag attached to the key set. Should you lose your keys, this number will enable an authorized Kia dealer to duplicate the keys easily. Remove the ...