Kia Soul: Auto start - ISG (Idle stop and go) system - Driving your vehicleKia Soul: Auto start

Kia Soul 2009-2013 AM Owner's Manual / Driving your vehicle / ISG (Idle stop and go) system / Auto start

To restart the engine from idle stop mode

• Release the brake pedal.
or
• Move the shift gear to the R (Reverse) position or the sports mode while depressing the brake pedal.

The engine will start and the green AUTO STOP indicator (on the instrument cluster will go out.) on the instrument cluster will go out.

The engine will also restart automatically without the driver’s any actions if the following occurs:

- When a certain amount of time has passed with the climate control system on.
- When the front defroster is on.
- The brake vaccum pressure is low.
- The battery charging status is low.
- The vehicle speed exceeds 1 MPH (1 km/h).
- The fan speed is in the highest position when the air conditioning is on.
- Engine is turned off by Auto Stop for a long time.
- If you unfasten the seat belt or open the driver's door while depressing the brake pedal.

The green AUTO STOP indicator (on the instrument cluster will blink for 5 seconds and a message “Auto Start” will) on the instrument cluster will blink for 5 seconds and a message “Auto Start” will appear on the LCD display (if equipped).

    Auto stop
    Type A Type B To stop the engine in idle stop mode Stop the vehicle completely by pressing the brake pedal. You must reach a speed of at least 5 mph (8 km/h) since last idle stop. The engine ...

    Condition of ISG system operation
    The ISG system will operate under the following condition: - The driver’s seat belt is fastened. - The driver’s door and engine hood are closed. - The brake vaccum pressure is adequate. - The ...

    See also:

    To decrease the cruising speed
    Follow either of these procedures: Push the SET - switch and hold it. Your vehicle will gradually slow down. Release the switch at the speed you want to maintain. Push the SET - switch and ...

    Power Door Lock Switch Diagnosis With GDS
    1. The BCM can be diagnosed by using the GDS. The BCM communicates with the GDS which then displays inputs and outputs along with codes. It will be able to ...

    Checking the tire inflation pressure
    1.After driving approximately 4 ~6miles(7~10km or about 10min), stop at a safety location. 2.Connect connection hose (9) of the compressor directly to the tire valve. 3.Plug the compressor power c ...