Kia Soul: Air Conditioner Refrigerant
Use only service equipment that is U.L-listed and is certified to meet
the requirements of SAE J2210 to remove R-134a from the air conditioning system.
|
If accidental system discharge occurs, ventilate the work area before
resume of service.
Additional health and safety information may be obtained from the refrigerant
and lubricant manufacturers.
Refrigerant Leak Test
Always conduct a leak test with an electronic leak detector whenever leakage
or refrigerant is suspected and when conducting service operations which are
accompanied by disassembly or loosening or connection fittings.
In order to use the leak detector properly, read the manual supplied
by the manufacturer.
|
If a gas leak is detected, proceed as follows:
1. |
Check the torque on the connection fittings and, if too loose,
tighten to the proper torque. Check for gas leakage with a leak detector
(A).
|
2. |
If leakage continues even after the fitting has been tightened,
discharge the refrigerant from the system, disconnect the fittings,
and check their seating faces for damage. Always replace, even if the
damage is slight.
|
3. |
Check the compressor oil and add oil if required.
|
4. |
Charge the system and recheck for gas leaks. If no leaks are found,
evacuate and charge the system again.
|
Refrigerant Recovery
Use only service equipment that is U.L-listed and is certified to meet
the requirements of SAE J2210 to remove HFC-134a(R-134a) from the air conditioning
system.
|
If accidental system discharge occurs, ventilate the work area before
resume of service.
Additional health and safety information may be obtained from the refrigerant
and lubricant manufacturers.
1. |
Connect a R-134a refrigerant
Recovery/Recycling/Charging system (A) to the high-pressure service
port (B) and the low-pressure service port (C) as shown, following the
equipment manufacturer's instructions.
|
2. |
Measure the amount of refrigerant oil removed from the A/C system
after the recovery process is completed. Be sure to install the same
amount of new refrigerant oil back into the A/C system before charging.
|
System Evacuation
Use only service equipment that is U.L-listed and is certified to meet
the requirements of SAE J2210 to remove HFC-134a(R-134a) from the air conditioning
system.
|
If accidental system discharge occurs, ventilate the work area before
resume of service.
Additional health and safety information may be obtained from the refrigerant
and lubricant manufacturers.
1. |
When an A/C system has been opened to the atmosphere, such as
during installation or repair, it must be evacuated using a R-134a refrigerant
Recovery/Recycling/Charging system. (If the system has been open for
several days, the receiver/drier should be replaced, and the system
should be evacuated for several hours.)
|
2. |
Connect a R-134a refrigerant Recovery/Recycling/Charging system
(A) to the high-pressure service port (B) and the low-pressure service
port (C) as shown, following the equipment manufacturer's instructions.
|
3. |
If the low-pressure does not reach more than 93.3 kPa (700 mmHg,
27.6 in.Hg) in 10 minutes, there is probably a leak in the system. Partially
charge the system, and check for leaks (see Refrigerant Leak Test.)
|
4. |
Remove the low pressure valve from the low-pressure service port.
|
System Charging
Use only service equipment that is U.L-listed and is certified to meet
the requirements of SAE J2210 to remove HFC-134a(R-134a) from the air conditioning
system.
|
If accidental system discharge occurs, ventilate the work area before
resume of service.
Additional health and safety information may be obtained from the refrigerant
and lubricant manufacturers.
1. |
Connect a R-134a refrigerant
Recovery/Recycling/Charging system (A) to the high-pressure service
port (B) as shown, following the equipment manufacturer's instructions.
|
2. |
Add the same amount of new refrigerant oil to the system that
was removed during recovery. Use only specified refrigerant oil. Charge
the system with [550 ± 25g (19.4 ± 0.88oz.)] R-134a refrigerant. Do
not overcharge the system the compressor will be damaged.
|
Body
...Air conditioner refrigerant/compressor Inspection
Compressor RPM check 1. Push the A/C control switch ON. 2. Check the engine RPM. &nb ...See also:
California perchlorate notice
Perchlorate Material-special handling may apply, See www.dtsc.ca.gov/hazardouswaste/p
erchlorate.
Notice to California Vehicle Dismantlers:
Perchlorate containing materials, such as air bag inflat ...
Water pump Troubleshooting
Symptoms
Possible Causes
Remedy
Coolant leakage
•
From the bleed hole of the water pump
Visually ...
Trip interruption
Trip interruption expense benefits are provided in the event that a warranty-related
disablement occurs more than 150 miles from your home, and the repairs require more
than 24 hours to complete. ...