Kia Soul: Adjustment - Panorama Sunroof - Body (Interior and Exterior)Kia Soul: Adjustment

Kia Soul 2014-2019 PS Service Manual / Body (Interior and Exterior) / Panorama Sunroof / Adjustment

Inspect Glass Alignment
1.
Inspect the alignment of the movable glass (C) that is between the front (A) and rear (B) glass and if needed adjust it.

Alignment adjustment
Standard value [mm(in.)]
(1) Front edge : 0 mm (0 in.)
(2) Rear edge : 0 mm (0 in.)

2.
Completely open the movable glass using the panorama sunroof switch.
3.
Remove both sides of the decoration cover (A) by pulling it in the direction of the arrow.

4.
Completely close the movable glass using the panorama sunroof switch.
5.
Adjust the height of the glass by slighty loosening the screws (A).
  
Be careful not to damage the screw.

Emergency operation
1.
Use the panorama sunroof emergency operation only when you have to open or close the sunroof when there is a problem with the engine.
2.
Use a hexagon wrench to open or close the panorama sunroof after removing the roof trim. Do not apply too much force when opening or closing the panorama sunroof.
[Movable Glass Motor ]

[Roller Blind Motor]

3.
If needed reset the panorama sunroof according to the reset method.
    Components
    1. Roof side moulding [LH] 2. Roof side moulding [RH] 3. Movable glass 4. Wind deflector 5. Decoration cover [LH] 6. Decoration cover [RH] 7. Center cover 8. Panor ...

    Movable Glass Replacement
    1. Completely open the movable glass using the panorama sunroof switch. 2. Remove both sides of the decoration cover (A) by pulling it in t ...

    See also:

    AUX(Auxiliary) Jack Removal
    1. Disconnect the negative (-) battery terminal. 2. Remove the floor console upper cover. (Refer to Body - "Floor Console Assembly& ...

    Driver's and passenger's front air bag
    Driver’s front air bag Passenger’s front air bag Your vehicle is equipped with an Advanced Supplemental Restraint (Air Bag) System and lap/shoulder belts at both the driver and passenger s ...

    Closing the fuel filler lid
    1. To install the cap, turn it clockwise until it “clicks”. This indicates that the cap is securely tightened. 2. Close the fuel filler lid and push it in lightly making sure that it is securel ...