Kia Soul: Shift Lever. Removal - Automatic Transaxle Control System - Automatic Transaxle SystemKia Soul: Shift Lever. Removal

Kia Soul 2014-2019 PS Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Shift Lever. Removal

1.
Remove the shift lever knob & boots assembly (A) by Pulling in the upside.
2.
Remove the floor console assembly.
(Refer to Body - "Floor Console")
3.
Remove the rear heating joint duct (A).
4.
Disconnect the shift lever main connector.
5.
Remove the wiring (A) from the shift lever assembly.
6.
Remove the shift cable (A) from the shift lever assembly.
7.
Remove the shift lever aseembly (A) by removing the bolts.
Tightening torque :
8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)

    Shift Lever. Components
    1. Shift lever knob & boots aseembly 2. Shift lever assembly 3. Shift cable assembly 4. Shift cable retainer 5. Shift cable brakcet 6. Manual control lever ...

    Shift Lever. Installation
    1. Install in the reverse order of removal.    When installing, set room sid ...

    See also:

    Engine Control Module (ECM). Repair procedures
    Removal 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the battery. (Refer to Engine Electrical Syst ...

    Components
    ...

    Auto stop
    Type A Type B To stop the engine in idle stop mode Stop the vehicle completely by pressing the brake pedal. You must reach a speed of at least 5 mph (8 km/h) since last idle stop. The engine ...