Kia Soul: Removal
1. |
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
|
2. |
Disconnect the clutch switch connector (A).
|
3. |
Remove the clutch switch (B).
|
Inspection
Signal Circuit Inspection 1. Check clutch switch pull-up voltage (1) IG KEY "OFF", ENGINE "OFF". ...Installation
1. Install in the reverse order of removal. (1) Tighten the nut with the specified torque. Tightening ...See also:
Head Lamp Leveling Actuator Inspection with GDS
Initialization and diagnosis sequence by using GDS equipment.
Below content summarize the procedure for A/S using GDS.
No.
Procedure
1
Loc ...
Operation in foreign countries
If you are going to drive your vehicle in another country, be sure to:
Observe all regulations regarding registration and insurance.
Determine that acceptable fuel is available.
...
Technical Data
System voltage: DC 12 V
Working voltage: DC 10 - 15 V
Amperage rating: max. 15 A
Suitable for use at temperatures: -22 ~ +158°F (-30 ~ +70°C)
Max. working pressure: 87 psi (6 bar)
Size
Compres ...