Kia Soul: Rear Shock Absorber Replacement - Rear Suspension System - Suspension SystemKia Soul: Rear Shock Absorber Replacement

Kia Soul 2014-2019 PS Service Manual / Suspension System / Rear Suspension System / Rear Shock Absorber Replacement

1.
Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported.
2.
Remove the front wheel and tire (A) from front hub.
Tightening torque :
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)

  
•
Be careful not to damage to the hub bolts when removing the rear wheel and tire (A).
3.
Loosen the rear shock absorber (A) upper mounting bolt.
Tightening torque :
49.0 ~ 63.7N.m (5.0 ~ 6.5kgf.m, 36.2 ~ 47.0lb-ft)

4.
Loosen the bolt and then remove the rear shock absorber (A) from the torsion beam axle.
Tightening torque :
98.1 ~ 117.7N.m (10.0 ~ 12.0kgf.m, 72.3 ~ 86.8lb-ft)

    Rear Shock Absorber Components
    1. Shock absorber assembly 2. Dust cover 3. Bump stopper 4. Cup 5. washer 6. Insulator assembly 7. Lock nut ...

    Rear Shock Absorber Inspection
    1. Check the rubber parts for wear and deterioration. 2. Compress and extend the piston rod (A) and check that there is no abnormal resista ...

    See also:

    Introduction
    With the Tire Mobility Kit you stay mobile even after experiencing a tire puncture. The system of compressor and sealing compound effectively and comfortably seals most punctures in a passenger c ...

    Turn signals and lane change signals
    The ignition switch must be on for the turn signals to function. To turn on the turn signals, move the lever up or down (A). The green arrow indicators on the instrument panel indicate which t ...

    Crankshaft Position Sensor (CKPS). Troubleshooting
    Waveform This example shows a typical Crankshaft Position Sensor(CkPS) and Camshaft Position Sensor(CMPS) waveform at idle.The PCM controls the injection and ignition timing by using ...