Kia Soul: Rail Pressure Sensor (RPS). Description and Operation
Kia Soul 2014-2019 PS Service Manual / Engine Control / Fuel System / Engine Control System / Rail Pressure Sensor (RPS). Description and Operation
Description
Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures
the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor
element) built in the sensor converts the pressure to voltage signal. By using
this signal, the ECM can control correct injection amount and timing and adjusts
the fuel pressure with the fuel pressure regulator valve if the target pressure
and the actual pressure calculated by the RPS output signal are different.
Heated Oxygen Sensor (HO2S). Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the HO2S connector.
3.
Measure resistance between th ...
Rail Pressure Sensor (RPS). Specifications
Specification
...
See also:
Certification label
The certification label is located on the driver's door sill at the center pillar.
This label shows the maximum allowable weight of the fully loaded vehicle. This
is called the GVWR (Gross ...
Manual climate control system
1. Fan speed control knob
2. Mode selection button
3. Temperature control knob
4. Air intake control button (fresh/recirculated)
5. Front window defroster button
6. Rear window defroster button ...
Mode Control Actuator Description
The mode control actuator is located at the heater unit.
It adjusts the position of the mode door by operating the mode control
actuator based on the signal of the A/C control unit. Pressing ...