Kia Soul: Installation
1. |
Install in the reverse order of removal.
|
2. |
After be equipped, perform bleeding air procedure in clutch release
cylinder after pouring the brake fluid.
(Refer to Clutch System - "Clutch release cylinder")
|
Removal
1. Remove the clutch pedal mounting nuts (A). 2. Separate the push rod (C) after remove the pin (A) and washer (B). ...Clutch Tube
...See also:
Accelerator Pedal. Repair procedures
Removal
1.
Turn the ignition switch OFF and disconnect the negative (-) battery cable.
...
Rear combination light bulb replacement
(1) Tail light and side marker
(2) Rear turn signal light
(3) Back-up light
(4) Stop and tail light
(5) Tail light
(6) Tail/Stop light and side marker (LED)
1. Open the tailgate.
2. Loo ...
Air conditioner refrigerant/compressor Inspection
Compressor
RPM check
1.
Push the A/C control switch ON.
2.
Check the engine RPM.
&nb ...