Kia Soul: Emergency Fastening Device (EFD). Installation - Seat Belt Pretensioner - RestraintKia Soul: Emergency Fastening Device (EFD). Installation

Kia Soul 2014-2019 PS Service Manual / Restraint / Seat Belt Pretensioner / Emergency Fastening Device (EFD). Installation

1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least thirty seconds.
3.
Install the emergency fastening device with bolt (B).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

4.
Connect the emergency fastening device connector (A).
5.
Install the center pillar lower trim.
(Refer to Body - "Center pillar trim")
6.
Insert the seat belt to the emergency fastening device (A).

  
Make sure the lock pin is connected in properly.
7.
Reconnect the battery negative cable.
8.
After installing the emergency fastening device, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
    Emergency Fastening Device (EFD). Removal
    1. Disconnect the battery negative cable, and wait for at least thirty seconds before beginning work. 2. To remove the emergency fastening ...

    SRSCM
    ...

    See also:

    Description
    The starting system includes the battery, starter, solenoid switch, ignition switch, inhibitor switch (A/T), clutch pedal switch (M/T), ignition lock switch, connection wires and the battery ...

    ETC (Electronic Throttle Control) System. Repair procedures
    Inspection Throttle Position Sensor (TPS) 1. Connect the GDS on the Data Link Connector (DLC). 2. Start the engine and measure the output v ...

    Smart Key
    Smart Key Code Saving 1. Connect the DLC cable of GDS to the data link connector in driver side crash pad lower panel, turn the power on GDS. ...